XM Satellite Radio SA10085 - Manual (Page 13)

13
each available frequency until you have found an optimal frequency. In the
rare circumstance that you cannot find an acceptable open frequency,
change to a hard-wired FM modulator configuration using the separately
available FM Modulator Direct Wiring Adaptor described in the Available
Accessories section on page 29.
Note that you may need to repeat this procedure if you travel to areas with
different FM stations in order to ensure the most static-free performance.
In order to optimize the performance of this feature, the XM antenna should
be installed near your vehicle’s FM antenna following the procedure on page 22.
Screen Color
Change the color of the display by simply using the Tuning Wheel to scroll
through the seven color choices. Select a new color by pressing the Tuning
Wheel in.
Contrast
This control allows you to adjust the contrast of your display.
Audio Level
Use this to adjust the Roady2 audio-output level if it is too high, causing distor-
tion, or too low for your car. Most users will NOT need to change this level from
the factory setting. This is not a volume control. You should set the volume using
the audio system connected to your Roady2.
When in FM modulator mode (by leaving the audio jack on the side of Roady2
unplugged), this menu selection will instead read “FM Audio Level” and will let
you select from a limited number of FM audio level settings.
Section 4
Warning: When using this product it is always important to keep your eyes on the road and your
hands on the wheel. Not doing so could result in injury to you or to others or in property damage.