XM Satellite Radio SA10085 - Manual (Page 20)

20
Section 5
(a) Flat mount: Use the included Velcro ® pads and attach them to both the
back of Roady2 and the identified flat surface in your vehicle.
(b) Vent mount: Your Roady2 kit includes an optional
vent mount that can be used in place of the more
permanent Velcro
® or swivel mounts so you can
easily move your Roady2 and mount from car to
car. Assemble the mount by inserting the two
clips into the main piece, clipping them onto the
vent, and then positioning the pivoting kickstand
at the bottom, as shown in figure 6. Be careful
when applying and removing the vent mount clips to prevent damaging
the vent fins.
(c) Swivel mount: This mount gives you the ability to adjust the angle of your
Roady2 after it is installed. This mount uses a strong adhesive that is not
easily repositioned when installed, so please use care when choosing the
location and placing the mount. In addition, do not install this mount on a
leather surface.
(i) Clean the vehicle mounting surface with the enclosed surface prepara-
tion cleaning kit. Wipe with the towelette in only one direction. Do not
wipe the surface in a circular motion or back and forth. Dry area with a
clean, dry cloth. Wipe dry in the same direction again and then repeat
this cleaning process. Allow to air dry thoroughly to ensure effective
adhesion.
(ii) Clean the same surface with the enclosed alcohol prep pad. Wipe in
the same direction and manner as with the towelette. Dry the area
with a clean, dry cloth, wiping in one direction. Allow to air dry thor-
oughly. Ensure that the surface is at least 60°F.
(iii) Warm the car mount adhesive pad by using a hair dryer or by placing
the car mount on top of the vehicle’s defrost outlet for several minutes
with the heater on. Remove the liner from the adhesive pad and
Figure 6. Vent mount