XM Satellite Radio SA10085 - Manual (Page 9)

9
Section 3
Basic Operations
Turning Roady2 On and Off
Press on the Roady2. When first turned on, the receiver will
automatically tune in to the last channel listened to and recall the
previous settings.
Basic Channel Selection
Select a channel by number
1. Make sure that Roady2 is in Direct Entry mode. “Direct” should appear in the
upper right corner of the display. If A, B, or C appears, press until the
display says “Direct.”
2. Enter channel number using the number keys, i.e., 5 then 0 for Channel 50.
Set/select channel presets
Your Roady2 can store up to 30 preset channels. They are organized into
three different groups (Preset A, Preset B, and Preset C), each with 10
channels corresponding to the 10 number keys. For the tenth preset in
each group, press the “0” key.
Selecting channel presets
Press until an A, B, or C appears in the upper right corner of the
display. Press the number key corresponding to the desired preset.
Setting channel presets
1. Tune in the channel you want to register as a preset, making sure it is playing.
2. Select either Preset A, Preset B, or Preset C by pressing until an A,
B, or C appears in the upper right corner of the display.
preset/direct
preset/direct
preset/direct
Warning: When using this product it is always important to keep your eyes on the road and your
hands on the wheel. Not doing so could result in injury to you or to others or in property damage.