Zanussi ZNM11X - Manual (Page 33)

INSTALLATION
INSTALLING THE APPLIANCE
1. Remove all packaging and check carefully for
any signs of damage.
2. If fitting the microwave oven above a
conventional oven (position A) then use the mylar
sheet provided.
a. Cut the Mylar sheet to fit the internal width of
the unit.
b. Peel back the protective cover on the tape
and fix to the rear
of the shelf
so that it
covers the
service gap.
(See
diagram.)
3. Fit the appliance into the kitchen cupboard
slowly, and without force, until the front frame of
the oven seals against the front opening of the
cupboard.
4. Ensure the appliance is
stable and not leaning.
Ensure that a 5 mm gap
is kept between the
cupboard door above
and the top of the frame
(see diagram).
5. Fix the oven in position with the
screws provided.
The fixing points are located
on the top and bottom
corners of the oven (see
diagram, item 9, on page 4).
6. It is important to ensure that the installation of
this product conforms to the instructions in this
operation manual and the conventional oven
manufacturer’s installation instructions.
5 mm
Mylar sheet
Conventional
oven
Inter
nal
width
Service
gap
The microwave can be fitted in position A or B:
Position A Position B
Conventional
oven
Chimney Chimney
POSITION NICHE SIZE CHIMNEY Gap Between
W D H (min) Cupboard & Ceiling
A 560x550x450 50 50
B 560x500x450 40 50
Measurements in (mm)
31