ZyXEL Communications Prestige 314 PLUS - Manual (Page 69)

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
NAT 4-7
The following figure shows how you apply NAT to the remote node in menu 11.1.
Step 1. Enter 11 from the main menu.
Step 2. Move the cursor to the Edit IP field, press the [SPACE BAR] to select Yes and then press
Step 3. [ENTER] to bring up Menu 11.3 - Remote Node Network Layer Options.
Figure 4-4 Menu 11.3 — Applying NAT to the Remote Node
The following table describes the options for Network Address Translation.
Table 4-3 Applying NAT in Menus 4 & 11.3
FIELD OPTIONS DESCRIPTION
Full
Feature When you select this option the SMT will use Address Mapping Set 1
(menu 15.1 - see section 4.3.1 for further discussion). You can configure
any of the mapping types described in Table 4-2. Choose Full Feature if
you have multiple public WAN IP addresses for your Prestige.
None NAT is disabled when you select this option.
Network
Address
Translation
SUA Only When you select this option the SMT will use Address Mapping Set 255
(menu 15.1 - see section 4.3.1). Choose SUA Only if you have just one
public WAN IP address for your Prestige.
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address: N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= Full Feature
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.