Zoom PS-02 - Manual (Page 63)

63
select one. The effect parameter setting changes, depending on the
selected effect type.
The Effect Edit menu lets you select the On/Off setting for each effect
module and change the value of the effect parameters.
◆
Basic operation steps for Effect Edit menu
1.
From the Effect menu, use the patch [
▼]/[▲] keys to select
the patch to edit.
2.
Press the [EDIT] key.
The unit switches to the Effect Edit menu, and the indication "EDIT"
is shown on the display.
The dot corresponding to the module currently selected for editing
flashes, and the name and setting of the parameter that was last edited
for that module (or the effect type used by that module) are shown on
the display.
• If the Edit menu was called immediately after switching patches, the
DRIVE TYPE is displayed. If the Edit menu was called after performing
Easy Edit, the last edited module is displayed.
• If the currently selected module is Off, the indication "-OFF-" is shown.
3.
To select the effect module for editing, use the cursor
[
]/[ ] keys.
The flashing dot moves left or right, and the parameter name (or
effect type used in the module) shown on the display changes
accordingly.
DRIVE CAB ZNR EQ1 EQ2 MOD REV TOTAL
Last edited
parameter value
Last edited parameter name (or effect type name)
Approximate setting of parameter that can be adjusted with sliders 1 - 3
Currently selected
module
Refer
e
nce
Guide