Pad play mode operation, Playing samples in pads 1 - 8, Step – Zoom ST-224 User Manual

Page 25: Hit one of pads 1 - 8

Advertising
background image

25

Pad

Play

Mode

Operation

The corresponding LED lights up.

While the pad is pressed, its LED is lit and the sample assigned to the

pad is played from start to end. Playback of the sample then stops.

(This is called "one-shot playback".)

• The default operation mode is "gate playback" where the

sample is only played for as long as the pad is held down. The
mode can be changed to the trigger (or retrigger) mode as
described on

page 33

, some of factory preset sounds are set in

this mode.

• While a pad is being pushed, the bank cannot be switched. To

switch banks without sound interruption, choose loop playback
in step 3.

The sample will then be played repeatedly in a continuous loop.

(This is called "loop playback".)

• The action of the pad when the [LOOP/MARK] pad is pressed

depends on whether the pad playback mode (

p. 33

) is set to

gate playback or trigger (retrigger) playback.

• When a pad set to gate playback is hit while holding down the

[LOOP/MARK] pad, loop playback continues in the hold state
also when the pad is released. To stop playback, hit the same
pad again.

• If the sound of a pad set to trigger (retrigger) playback is playing,

and the pad is hit again while holding down the [LOOP/MARK]
pad, the sound does not stop (loop playback will begin after the
sample has played through). To stop playback, hit the same pad
again.

HINT

HINT

NOTE

BANK

3

BANK

2

BANK

SONG

PAD

1

FUNCTION

EFFECT SYNC

EDIT 1

LOOP/MARK

4

SHIFT

OFFSET

6

SWING

PANNING

8

MIDI

TRIGGER/GA

TE

2

QUANTIZE

TUNING

SOURCE

SOURCE MIX

5

PRE COUNT

END POINT

3

TIME SIG

START POINT

1

BAR LENGTH

LEVEL

7

CLICK VOLUME

REVERSE

Use the [BANK 1] - [BANK 3] keys to select the desired bank.

1

STEP

Hit one of pads 1 - 8.

2

STEP

To play the sample continuously, hold the [LOOP/MARK] pad down while hitting the pad.

3

STEP

This section explains operation of the unit in pad play mode. In this mode, pads are played to produce their

assigned samples. This is the basic operation mode of the ST-224. The playback position and playback mode of

each sample are also adjusted in this mode.

Pad Play Mode Operation

Playing Samples In Pads 1 - 8

BANK

1

BANK 1– 3 keys

Pads 1 – 8

LOOP/MARK

+

Pads 1 – 8

[LOOP/MARK] pad

Advertising