Zoom ST-224 - Manual (Page 69)

The ST-224 becomes ready for use immediately, because the loading
process from backup memory is skipped. The main memory will be
empty.
The indication "init" appears on the display.
To cancel the initialization, press the [EXIT] key.
The ST-224 is reset to the factory default condition, and the
preprogrammed sound sources (samples) are loaded into the main
memory.
Proceed with care. When initialization is performed, all bulk data
stored in the backup memory will be erased.
NOTE
POWER
BACKUP
LOAD SAVE INTERNAL/DATA CARD
BACKUP
LOAD SAVE INTERNAL/DATA CARD
POWER
POWER
Turn off the ST-224. 1 STEP
While holding down the [SAVE] key, turn the unit back on again. 2 STEP
Press the [SAVE] key again. 3 STEP
69
Other
Functions
Resetting the ST-224 to the Factory Default (Initializing)
You can reset the unit to the factory default condition as follows.
EXIT
Hold down the [EXIT] key and turn the ST-224 on. 1 STEP
Initializing Without Loading Backup Memory Data (Quick Start)
Normally, the ST-224 loads data from backup memory into the main memory every time the unit is
turned on. This causes a certain delay until the unit can be used for playing or sampling. When wishing to
skip this step and get the unit ready for use quickly, perform the following steps.
Other Functions
SONG
PAD
FUNCTION
PAD ASSIGN CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
EDIT 2 EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
COPY DELETE
BACKUP EXIT
SPECIAL LOAD SAVE INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP BPM
MEASURE SAMPLE/SONG BEAT
SONG
PAD
FUNCTION
PAD ASSIGN CAPACITY ERASE OPTIMIZE
PLAY/STOP RECORD
EDIT 2 EFFECT
ON/OFF
PAD ENABLE
A
B
EFFECT SYNC
COPY DELETE
BACKUP EXIT
SPECIAL LOAD SAVE INTERNAL/DATA CARD
+ –
AUTO SYNC
PLAYLIST
TAP BPM
MEASURE SAMPLE/SONG BEAT