X10 Wireless Technology IR10A - Manual (Page 11)

21 20
Learning Side Keys
At the Home screen press the Side Key
next to Learn.
Then press any of the Side Keys K1-
K5 to the left of the screen.
Select the device you want to learn keys
for. In this example we only have a TV,
Cable Box and Satellite Receiver set
up, so the rest are grayed out, but you
can still select any of the devices to
learn commands for. In this case we
selected TV.
Some typical “extra” keys are already set
up, (depending on the Mode you se-
lected), the rest of them are called L6,
L7, L8, etc., 27 keys in total. (You can
rename them later). Press the Side Key
that you want to learn a command under.
(Note can choose one that already has a
name, so as to “learn over it” and then
later rename it). Let’s select L7.
Before learning the second key in the
Macro, you can if desired, set a delay
(1-10 secs) after which the command
stored in the Macro will be sent. For
example your TV might require a few
seconds after turning it on before it will
respond to a Channel Up/Down
command. (Repeatedly press the Side
Key next to Set Delay, or enter the delay
directly with the numeric keys, 0-9).
Macros - Main Keys, cont.
In this case let’s set a 1 second delay
between commands. Then point your
existing remote at the bottom of the
IR10A remote and press OK when
you’re ready.
You then press the second key on your
original remote that you want to add to
the Macro.
When success is displayed you can
continue adding keys to the Macro, and
then press Done when you’re finished.