X10 Wireless Technology IR10A - Manual (Page 6)

11 10
Once you’ve gone through the Wizard
and set up at least a TV, and set up more
devices, or skipped the rest of them, you
arrive at screen (1) to the right.
Setting Up Your Favorites
(1)
(2)
(3)
(4)
Setting Up Your Favorites, cont.
If you want to add a label to the logo press the Side Key next
to Label. This is optional so if you don’t want to add a label to
the logo you can just select Save to save the setting for this
favorite. If you save this favorite, Set Favorite 2 of 10 is now
shown at the bottom of the screen to indicate that you can add
another favorite channel. Again just press a channel number
key on the remote, choose a logo and change the Device Type
(if you want to). Add a few more favorites (up to 10). You can
add more later, or delete or edit them later, or even reorder
their positions. Select Done when you’re finished setting up
favorites.
Press any digit key, say digit 4, to enter
a channel number. This takes you to
screen (2). You can enter more digits if
desired. The channel number can
include a dash (-) for digital channels,
e.g., 2-3, or can include ENTER, or OK,
if your device requires it to change
channels, e.g. 472Ok, or 550Ent.
Now you press the Side Key next to
Pick Logo on screen (2). You are shown
a screen (3) of popular channel logos.
You can select Next (Side Key 10) or
Back (Side Key 5) to see more logos. In
this example we pressed the NBC logo
(Side Key 4). Screen (4) now shows that
we’ve chosen channel 4 and the NBC
logo. Note, you could also select the top
left position which would display “4” as
the favorite rather than a logo.
The Default device is this case was Sat,
but you can select Pick Device to
change it. In this case we changed it to
Cable. Make sure you select the
device that you want each favorite to
control, e.g. TV, Cable, or Sat.
If you select Label, you see the screen to
the right with a small label on top of the
logo. Initially the label will be the channel
number for that logo. If you Save this, the
logo will have a small label representing
the channel number for that logo in it’s
bottom right hand corner, see screen (5).
(5)
But you can type in a new label if you
want one. You enter the new name for
the key using the numeric keys on the
remote, in a similar fashion to typing in
text on a cell phone.
E.G. in this example we pressed the 5
key twice to enter the letter K. Then we
waited a second and pressed the 4 key
repeatedly until the letter I was
displayed. Then we waited a second and
pressed 6 to select N. Then we waited a
second and pressed the 4 key to select
G. See next page.