X10 Wireless Technology IR10A - Manual (Page 20)

39 38
Troubleshooting
The Favorites you set up don’t operate your device.
• Make sure you selected the correct device (TV, Cable, Sat,
etc., when you set up each favorite. See Add/Edit Favorites
page 29 to change the device type for your favorite(s).
The Remote’s hard keys do not operate your product.
• Make sure the remote is set to the correct Mode by
pressing the MODE key follow by the appropriate Side
Key for the device mode you desire.
• Program the remote with a new code.
• The remote may not contain the code for your device. Try
learning the codes you need from your old remote.
• Install new batteries.
The remote does not operate some features of your product.
• Program the remote with a new code.
• The remote may not be able to operate all features of your
product or key names might be different than your product.
Try learning codes from your old remote.
X10.com, a division of X10 Wireless Technology, Inc. (X10)
warrants X10 products to be free from defective material and
workmanship for a period of one (1) year from the original date
of purchase at retail. X10 agrees to repair or replace, at its sole
discretion, a defective X10 product if returned to X10 within the
warranty period and with proof of purchase. If service is required
under this warranty:
Call 1-800-442-5065, or visit www.x10.com, or e-mail
[email protected].
For help or more information on setup, please visit:
http://www.x10.com/support
12 Month Limited Warranty
X10 Home Control
If you own or purchase an X10 IR Command Console, Model
IR543 and X10 Lamp, Appliance, and Wall Switch Modules
you’ll be able to control lights and appliances from your
IR10A iconRemote. You point the iconRemote at the IR543, it
receives IR commands and converts them to X10 commands.
Refer to page 34 and set up code 0401 under AUX (or any
other mode you prefer). Then in AUX mode (for example)
press a number button on the iconRemote corresponding to the
X10 Module you want to control, then press CHANNEL + to
turn the module on, CHANNEL – to turn it off, VOLUME + to
brighten Lamp and Wall Switch Modules, and VOLUME – to
dim them. You can also press the POWER button to turn on
ALL lights connected to Lamp and Wall Switch Modules and
press MUTE to turn off all your X10 modules (including
Appliance Modules). Having problems with learning?
• See Learning Tips on page 16.
• If some learned keys transmit multiple times, e.g. if a
learned Channel Up key changes more than one channel
when you press it, or Up/Down/Left/Right navigation keys
move more than one step when you press the learned key;
try just giving the key to be learned a quick press (when
you learn it) rather than holding the key pressed until the
screen displays Success.
Your TV turns on when you press a Favorite key.
• Some types of TV, e.g. Philips flat panel TVs turn on and
go to the selected channel when you press a channel
number while the TV is off. So for this type of TV pressing
a favorite key will do the same thing (but it might not work
for 3 digit channels, e.g. 550).
Forgot your KidSafe code?
• Just remove and reinsert the batteries to reset KidSafe (but
don’t let your Kids see this Owner’s Manual).
Troubleshooting, cont.