X10 Wireless Technology IR10A - Manual (Page 13)

25 24
Line up the remotes and press OK when
you’re ready.
Learning Macros, cont.
Press Side Key K8 next to “Add Key to
Macro” to add more keys.
You can set a delay (1-10 secs) after
which the command stored in the Macro
will be sent. (Repeatedly press Side Key
K9 next to Set Delay, or enter the delay
directly with the numeric keys, 0-9).
In this case we set a 2 second delay.
Next press the key (on the other remote)
for the function you want to learn. Hold
the key pressed until the screen says that
the command was successfully learned.
Note for some types of key you might
need to hold the key pressed, but for
other types a quick press is sufficient.
Experiment a bit. If keys you learn are
sent multiple times try learning them
with just a quick press.
A Macro could include the Power key for
your TV, followed by the Power key for
your Cable box, followed (after a 2
second delay), by digit 4 from your cable
remote. Then when you later activate this
Macro it will turn on your TV, turn on
your cable box, wait 2 seconds then set
the cable box to channel 4.
At the Home screen press the Side Key
next to Learn.
Then press any Side Key K1-K5 to the
left to learn a Macro that you’ll save to a
Side Key (and later rename it if desired).
Learning Macros (Side Keys)
Select the device you want to learn keys
for. In this example we only have a TV,
Cable Box and Satellite Receiver set up,
so the rest are grayed out, but you can
still select any of the devices to learn
commands for. E.G., in this case we
selected DVR.
Then select the Side Key that you want to
store the Macro under. For example, L1.