ZyXEL Communications GS-2724 - Manual (Page 259)

Chapter 38 Introducing Commands
GS-2724 User’s Guide
259
38.11.6 config-vlan Commands
The following table lists the vlan commands in configuration mode.
igmp query-interval Sets the igmp query interval on
the Switch. This variable
specifies the amount of time in
seconds between general query
messages sent by the router.
13
igmp query-max-
response-time <1-25> Sets the maximum time that the
router waits for a response to an
general query message.
13
igmp last-member-
query-interval <1-25> Sets the amount of time in
seconds that the router waits for
a response to a group specific
query message.
13
rip direction
<Outgoing|Incoming|Bo
th|None> version
<v1|v2b|v2m> Sets the RIP direction in this
routing domain as well as the
version number.
13
no ip igmp Disables IP IGMP in this routing
domain.
13
Table 92 interface route-domain Commands (continued)
COMMAND DESCRIPTION
PRIVILEG
E
Table 93 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
PRIVILEG
E
vlan
<vlan-id> Creates a new VLAN group. 13
exit Leaves the VLAN configuration
mode.
13
fixed <port-list> Specifies the port(s) to be a
permanent member of this VLAN
group.
13
forbidden <port-
list> Specifies the port(s) you want to
prohibit from joining this VLAN
group.
13
help Displays a list of available VLAN
commands.
13
inactive Disables the specified VLAN. 13
ip address <ip-address> <mask> Sets the IP address of the
Switch in the VLAN.
13
<ip-address> <mask>
manageable Sets the IP address of the
Switch in the VLAN and allow
remote management to this IP
address.
13
default-gateway <ip-
address> Sets the default gateway IP
address in this VLAN.
13
name <name-str> Specifies a name for
identification purposes.
13