Zanussi ZKH 2145 - Manual (Page 16)

For cottons and synthetic the lowest value you can
select is 900 r.p.m.
5. Set the dryness degree by pressing button 3. The
display shows the whole duration of the washing and
the set drying cycle.
6. Start the programme by pressing button 7. The time
remaining is updated every minute on the display.
7. At the end of the programme turn the selector dial to
the position to switch the machine off. Remove
the laundry.
NON-STOP programme - Washing and Timed
Drying
The recommended load size is 3,5 kg for cotton and 2 kg
for synthetic.
It is also possible to dry up to 5 kg of cotton items
(see the «Drying Programme » table).
Caution! Do not use a dosing device/ball when
carrying out a washing and drying programme.
1. Load the laundry and add detergent and fabric soft-
ener.
2. Switch the machine on by turning the selector dial to
the set washing programme/fabric.
3. Select the required options by pressing the relevant
buttons.
If possible, do not select a spin speed lower than
that proposed by the appliance to avoid too long a
drying time therefore saving energy.
In any case the reduction of the spin speed is only
possible after selecting drying.
The lowest values you can select are 900 r.p.m. for
cottons and synthetics and 700 r.p.m. for delicate
fabrics.
4. Set the drying time by pressing button 4. The display
shows the whole duration of the washing and the set
drying cycle.
5. Start the programme by pressing button 7. The time
remaining is updated every minute on the display.
6. At the end of the programme turn the selector dial to
the O position to switch the machine off and remove
the laundry.
Care and cleaning
Warning! You must DISCONNECT the appliance
from the electricity supply, before you can carry out
any cleaning or maintenance work.
Descaling
The water we use normally contains lime. It is a good idea
to periodically use a water softening powder in the ma-
chine. Do this separately from any laundry washing, and
according to the softening powder manufacturer's instruc-
tions. This will help to prevent the formation of lime de-
posits.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
Cleaning the dispenser drawer
The washing powder and additive dispenser drawer
should be cleaned regularly.
Remove the drawer by
pressing the catch down-
wards and by pulling it
out. Flush it out under a
tap, to remove any traces
of accumulated powder.
To aid cleaning, the top
part of the additive com-
partment should be re-
moved.
16