Zanussi ZKH 2145 User Manual

Page 21

Advertising
background image

Problem

Possible cause/Solution

The door will not open:

The programme is still running.
• Wait the end of washing cycle.

The door lock has not been released.
• Wait until the pilot light 9 goes off.

There is water in the drum.
• Select drain or spin programme to empty out the water.

The machine vibrates is noisy:

The transit bolts and packing have not been removed.
• Check the correct installation of the appliance.

The support feet have not been adjusted
• Check the correct levelling of the appliance.

The laundry is not evenly distributed in the drum.
• Redistribute the laundry.

Maybe there is very little laundry in the drum.
• Load more laundry.

Spinning starts late or the machine

does not spin:

The electronic unbalance detection device has cut in because the laundry is

not evenly distributed in the drum. The laundry is redistributed by reverse rota-

tion of the drum. This may happen several times before the unbalance disap-

pears and normal spinning can resume. If, after 10 minutes, the laundry is still

not evenly distributed in the drum, the machine will not spin. In this case, re-

distribute the load manually and select the spin programme.
• Redistribute the laundry.

The load is too small.
• Add more items, redistribute the load manually and then select the spinning

programme.

The machine does not dry or does

not dry properly:

The drying time has not been selected.
• Select the drying time.
The water tap is not turned on.
• Open the water tap.
The drain filter is clogged.
• Clean the drain filter.

The machine is overloaded.
• Reduce the laundry load.

The selected drying time or the drying programme was not suitable for the

laundry.
• Select the suitable drying time/programme for the laundry.

The machine makes an unusual

noise:

The machine is fitted with a type of motor which makes an unusual noise com-

pared with other traditional motors. This new motor ensures a softer start and

more even distribution of the laundry in the drum when spinning, as well as

increased stability of the machine.

No water is visible in the drum:

Machines based on modern technology operate very economically using very

little water without affecting performance.

21

Advertising