Zanussi ZKH 2145 - Manual (Page 24)

35°
45°
Open the porthole and extract the inlet hose.
Connect the hose with the angled connection to the ma-
chine. Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the position of
your water tap.
Set the hose correctly by loosening the ring nut.
Connect the hose to a tap
with a 3/4” thread.
• After positioning the inlet hose, be sure to tighten
the ring nuts again to prevent leaks.
• The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially de-
signed for this type of use.
Water-stop device
A
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks in
the hose which could develop due to natural ageing of
the hose. This fault is shown by a red sector in the win-
dow «A». Should this occur, turn the water tap off and
refer to your Service Centre to replace the hose.
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a
sink using the plastic hose
guide supplied with the
machine.
In this case, make sure the end cannot come unhooked
when the machine is emptying. This could be done by
tying it to the tap with a piece of string or attaching it to
the wall.
In a sink drain pipe branch. This branch must be above
the trap so that the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a height of not less than 60
cm and not more than 90 cm. The end of the drain hose
must always be ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside diameter of
the drain hose. The drain hose must not be kinked.
24