Figure 50 electromagnetic interference (emi), Wall-mounting instructions – ZyXEL Communications PLA-470 User Manual
Page 83
Appendix A Product Specifications
PLA-4xx Series User’s Guide
83
Figure 50 Electromagnetic Interference (EMI)
Wall-mounting Instructions
Complete the following steps to hang your PLA-400/400 v2/401/401 v2/402 v2/470/470 v2/
491 on a wall.
"
See
for the size of screws to use and how far apart to
place them.
1 Select a high position on a sturdy wall that is free of obstructions.
2 Drill two holes for the screws. The distance between the centers of the holes is listed in
the product specifications appendix.
1
Be careful to avoid damaging pipes or cables located inside the wall when
drilling holes for the screws.
3 Do not insert the screws all the way into the wall. Leave a small gap of about 0.5 cm
between the heads of the screws and the wall.
4 Make sure the screws are snugly fastened to the wall. They need to hold the weight of
the PLA-4xx with the connection cables.
5 Align the holes on the back of the PLA-4xx with the screws on the wall. Hang the PLA-
4xx on the screws.
50-60mbps
20-30mbps
HAIR DRYER
CONNECTED
NO EMI FILTER
50-60mbps
46-56mbps
HAIR DRYER
CONNECTED
WITH EMI FILTER
APPLIANCE WITHOUT EMI FILTER
APPLIANCE WITH EMI FILTER
HOMEPLUG AV BITRATE
HAIR DRYER
DISCONNECTED