3Com WX4400 3CRWX440095A - Manual (Page 151)

151 C HAPTER 7: C ONFIGURING SNMP
This command configures target 1 at IP address 10.10.40.9. The target’s
SNMP engine ID is based on its address. The MSS SNMP engine will send
notifications based on the default profile, and will require the target to
acknowledge receiving them.
The following command configures a notification target for
unacknowledged notifications:
WX1200# set snmp notify target 2 10.10.40.10 v1 trap
success: change accepted.
Enabling the SNMP
Service
To enable the MSS SNMP service, use the following command:
set ip snmp server {enable | disable}
The following command enables the SNMP service:
WX1200# set ip snmp server enable
success: change accepted.
Displaying SNMP
Information You can display the following SNMP information:
„
Version and status information
„
Configured community strings
„
User-based security model (USM) settings
„
Notification targets
„
SNMP statistics counters
Displaying SNMP
Version and Status
Information
To display SNMP version and status information, use the following
command:
display snmp status
Displaying the
Configured SNMP
Community Strings
To display the configured SNMP community strings, use the following
command:
display snmp community
Displaying USM
Settings
To display USM settings, use the following command:
display snmp usm