3Com WX4400 3CRWX440095A - Manual (Page 256)

256 C HAPTER 10: C ONFIGURING MAP A CCESS P OINTS
Displaying MAP
Information You can display the following MAP information:
„
MAP and radio-specific configuration settings
„
Connection information for Distributed MAPs configured on a WX
„
List of Distributed MAPs that are not configured on a WX
„
Connection information for Distributed MAPs
„
Service profile information
„
Radio profile information
„
Status information
„
Information about static IP addresses on Distributed MAPs
„
Statistics counters
„
Information about VLAN profiles configured for local switching
„
ARP table on an MSP
„
Forwarding Database (FDB) for an MSP
„
Information about the VLANs locally switched by a MAP
„
Information about ACLs used by the MAP
Displaying MAP
Configuration
Information
To display configuration information, use the following commands:
display ap config [apnumber [radio {1 | 2}]]
The command lists information separately for each MAP.
To display configuration information for MAP 59, type the following
command:
WX1200# display ap config 59
AP 59: serial-id: 1231, AP model: MP-422, bias: high, name:
AP59
upgrade-firmware: YES
force-image-download: NO
communication timeout: 10
location:
contact:
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 18, profile: default
auto-tune max-power: default,
load-balance-group: ,
load-balance-enable: YES,