3Com 1000 - Manual (Page 25)

2
I
N S T A L L A T I O N A N D
S
E T U P
Following Safety Information
Before installing or removing any components from
the Switch, or carrying out any maintenance proce-
dures, you must read the safety information pro-
vided in
Appendix A of this guide.
Positioning the Switch 1000
The Switch is suited for use in the office where it
can be wall-mounted, mounted in a standard
19-inch equipment rack, or free standing. Alterna-
tively, the unit can be rack-mounted in a wiring
closet or equipment room. A wall-mounting /
rack-mounting kit, containing two mounting brack-
ets and six screws, is supplied with the Switch.
When deciding where to position the unit, ensure
that:
■ You are able to meet the configuration rules
detailed in the following section.
■ The unit is accessible and cables can be con-
nected easily.
■ Cabling is away from:
■
Sources of electrical noise such as radios,
transmitters and broadband amplifiers.
■
Power lines and fluorescent lighting fixtures.
■ Water or moisture cannot enter the case of the
unit.
■ Air-flow around the unit and through the vents in
the side of the case is not restricted. We recom-
mend that you provide a minimum 25mm (1in.)
clearance.
■ No objects are placed on top of the unit.
■ Units are not stacked more than four high if
free-standing.