3Com 1000 - Manual (Page 52)

4-8 C HAPTER 4: M ANAGING T HE S WITCH 1000
STP Use this button to display screens for managing
Spanning Tree Protocol (STP) information for the
level of management you have chosen (port or
VLAN). Refer to
“Spanning Tree Protocol” on page
5-12 .
STP is not supported over Asynchronous Transfer
Mode (ATM). Consequently, if you specify that you
want to manage the Plug-in Module and the
Switch has an ATM OC-3c Module installed, the
STP button is not displayed.
SERVER Use this button to display the VLAN Server
screen, used for entering the IP address and com-
munity string of a VLAN server. For more informa-
tion about VLAN servers, refer to
“Virtual LANs
(VLANs)” on page 5-1 .
STATS Use this button to display statistics screens for
the level of management you have chosen (port or
unit). Refer to
Chapter 6 .
SDB Use this button to display the Unit Database
View screen, which is used to manage the Switch
Database. Refer to
“The Database View” on page
4-17 .
RESILIENCE Use this button to display resilient link
management screens for the level of management
you have chosen (port or unit). Refer to
“Setting
Up Resilient Links” on page 4-19 .
You cannot set up resilient links if the Switch uses
Spanning Tree (STP). Consequently, the RESILIENCE
button is not displayed if STP is enabled.
Figure 4-9 Switch Management screen for VLAN level
SETUP Use this button to display setup screens for
the level of management you have chosen (port,
unit or VLAN). For information about the Port
Setup and Unit Setup screens, refer to
“Setting Up
the Switch Ports” and “Setting Up the Switch Unit”
in this chapter. For information about the VLAN
Setup screen, refer to
“Setting Up VLANs on the
Switch” on page 5-8 .