GE SECURITY Concord - Manual (Page 28)

Concord 20
Pager Messages
When an event is reported on a numeric pager, the following information is included:
Figure 8. Pager Messages
Although all three types of information can be reported on your pager, your pager service deter-
mines how the information will actually appear.
Event Code in Page
This part of the page let’s you know what has happened.
Sensor Number or User Number in Page
This part of the page let’s you know who or what is causing the event.
Touchpad Tamper
Bus Failures
• Opening and Closing Reports
• Latchkey Reports
• Notify by Exception Reports
Code Indicates
009 A sensor has been restored to its non-alarm state
111 System has been disarmed
115 Sensor test exit
118 System trouble has been fixed
119 System alarm condition has been cancelled
222 System armed to Level 2—STAY
333 System armed to Level 3—AWAY
555 System phone/sensor test
888 System has a trouble condition
999 System is in alarm condition
If a user arms the system to level 3 (AWAY) the pager will report that the system was armed to
level 3 (333). However, if the Auto Stay Arming feature is enabled and the user does not exit
the premises, the arming level will revert to level 2 (STAY) without notifying the pager. Refer to
the User Sheets in Appendix A to see whether this feature is on or off.
Code Indicates
000 System event not caused by a sensor or user
001 — 096 Sensor numbers 1 through 96
600 — 829 User codes 00 through 229 used
846 System Master code used
847 Installer code used
848 Dealer code used
850 Quick Arm used
Event Code Last four digits of central
station account number
Sensor number or user number