AT&T System 25 - Manual (Page 26)

Programming Speed Dialing Codes (Continued)
Using # as a Character
If you want to use a “ # " as an actual character, you must place
two “ # ”s in the programmed number.
For example, you may want to program 555-1111 followed by a
1.5 second pause, a “ # “, and 7777 into a Personal Speed Dialing
code.
You program: 5551111* # # 7777
This means:
5551111 (1.5 second pause) #7777
Using # with Speed Dialing Codes
When you want to have a Speed Dialing code as part of your
programmed number, you should use a single “ # ” for the code.
For example, you may want to program the System Speed
Dialing code “ # 100” into a Personal Speed Dialing code.
You program: #100
This means:
System Speed Dialing code # 100
Using #8 to Start End-to-End Signaling
When you place a “ #8” in a programmed number, you tell the
system to start end-to-end signaling.
For example, you may want to program both a telephone
number (to be dialed first), and an identification code (that
should be transmitted to the far end).
You program: 9*5554444** # 812345
This means: 9 (1.5 second pause) 5554444
(3 second pause)
(start end-to-end signaling) 12345
(Continued)
23