Powering up and booting, Powering up and booting 49 – 3Com 3C16895 User Manual
Page 49
Booting the Switch 7750
49
Powering up and
Booting
Turn on the power for the Switch 7750 and run the BootROM program. The
terminal displays the following information:
Starting......
RAM Line....OK
System is booting.....................
******************************************
* *
* Switch 7750 BOOTROM, Version 300 *
* *
******************************************
Copyright(C) 2001-2005 by 3Com Corporation, Inc.
Creation date: Mar 25 2003, 09:33:05
CPU type : MPC8260
CPU Clock Speed : 200Mhz
BUS Clock Speed : 66Mhz
Memory Size : 256MB
FAB64 self testing...............................
60X_SDRAM Data lines Selftest.............................OK!
60X_SDRAM Address lines Selftest..........................OK!
60X_SDRAM fast selftest...................................OK!
Please check LEDs.....................LEDs selftest finished!
Switch chip selftest......................................OK!
CPLD selftest.............................................OK!
The switch Mac address is .....................00E0.FC00.7505
Press Ctrl+B to enter Boot Menu... 5
To enter Boot Mode (see Chapter 6), press Ctrl+B during the 5 seconds that “Press
Ctrl+B to enter Boot Menu...5” is displayed. To perform decompression
immediately, press ESC while this message is displayed. If you do nothing, the
system enters the following auto-booting port within 5 seconds:
Auto-booting....................
Auto booting file is sw7750001.app
There are 2 files in this packet
FAB64 app file <<FAB64001.app>> is...OK
Decompress
Image...............................................................
....................................................................
....................................................................
....................................................................
..............OK!
Starting at 0x60000...
User interface Aux0 is available