Arcam D33 - Manual (Page 9)

e-9
english
using the remote control
Please keep in mind the following when using the
remote control:
< Ensure there are no obstacles between the
remote control and the remote sensor on the
front panel. The remote has a range of about 5
metres. (If the remote sensor is obscured, the
Ir in remote control input jack on the rear
panel is available. Please consult your dealer
for further information.)
< remote operation may become unreliable if
strong sunlight or fluorescent light is shining
on the remote sensor of the unit.
< replace the batteries when you notice a
reduction in the operating range of the
remote control.
notes on batteries:
< Incorrect use of batteries can result in hazards
such as leakage and bursting.
< Do not mix old and new batteries together.
< Do not use non-identical batteries together –
although they may look similar, different batteries
may have different voltages.
< Ensure the plus (+) and minus (-) ends of each
battery match the indications in the battery
compartment.
< remove batteries from equipment that is not
going to be used for a month or more.
< When disposing of used batteries, please comply
with governmental or local regulations that apply
in your country or area.
alternative code selection
In the rare situation that the Cr107 remote control
happens to operate another device in the room, the
Ir code can be changed to an alternative rC5 system
number.
To change the remote control to the alternate code:
1. Press and hold the 0 and / keys for 6 seconds until
the LED at the top of the remote remains lit.
2. Press OpT2 to select the alternative Ir codes (rC5
system code 28) or press OpT1 to select the
original code set (rC5 system code 27).
If no key is pressed within 10 seconds the remote will
return to normal operation.
note: the selection of the alternate codes is reset when
batteries are changed.
In addition to changing the remote handset, the D33
unit must also be reconfigured to respond to the
alternate codes. With the unit powered on, press the
OpTICAl 1 and AES/Ebu buttons simultaneously. The
FIlTER LED will flash to indicate remote code selection.
Press the FIlTER button to toggle between the normal Ir
codes ( FIlTER 1 LED flashing) and the alternative codes
( FIlTER 2 LED flashing). Press any other key to exit the
code selection mode.
The D33 is supplied with the Cr107 remote control.
remote
control
inserting batteries into the
remote control
2. Insert two ‘AAA’ batteries into the battery
compartment – facing opposite directions, as
in the diagram and the battery compartment
indication.
3. Slide the battery cover back into place.
1. Open the battery compartment by sliding
open the battery cover.