3M MP8746 - Manual (Page 34)

3M ™ Personal Projector MP8746/MP8747 34 © 3M IPC 2000
Technical Appendix
Connection to the Mouse Control
PS/2, ADB or Serial Mouse
1. Turn off the projector and computer, and connect the two units with the appropriate cable. For
PS/2 mouse control (for IBM and compatible), use the enclosed mouse cable. For others,
consult your dealer.
2. Disconnect the USB cable from the projector if it is connected. Then turn on the projector.
3. Turn on the computer.
4. Start the mouse function. If the mouse has not been started, reboot the computer (soft reboot or
reboot buttons). Refer to the descriptions of “DISC PAD” and “MOUSE/RIGHT BUTTON” on
page 12.
USB Mouse
1. Connect the projector and computer with a suitable commercially available USB cable.
Consult your dealer to get the cable, if needed.
2. Start the mouse function. Refer to the descriptions of “DISC PAD” and “MOUSE/RIGHT
BUTTON” on page 12.
✓ Note: • Before connecting, read the instruction manuals of the devices to be connected.
• In the case of laptop computers with an internal pointing device, the mouse control
will not work. In this situation, disable the internal pointing device and change the
BIOS setting to select an external mouse before the operations described in the steps
above.
• Some computers may not have utility program to operate a mouse.
• Refer to the computer hardware manual for details.
PS/2 Mouse
1
2
3
4
5
6 1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Projector Computer
CLK
DATA
SELO
RTS
+5V
GND
DATA
GND
+5V
CLK
5
10
15 14 13 12 11
9 8 7 6
4 3 2 1
6
4
2 1
3
5
CONTROL Terminal
D-sub 15-pin shrink jack
Mouse jack
Mini DIN 6-pin