3M M170 - Manual (Page 17)

Chapter 2 Setting Up Your M170 FPD Monitor 17
Figure 8. Adjusting the Viewing Angle
Lift up latch to release lock and raise
or lower display to suit your needs. Push down latch to engage lock
and stabilize display position.
Lift up on the latch to release lock. Adjust the M170 FPD by
pushing or pulling on the top front of the monitor until the
screen is at the best viewing angle for you. Then push down
on latch to engage locking mechanism and stabilize display
position.
Installing the Video Card and Video Driver
Before you can connect your touch monitor, make sure your computer has a video card
and driver already installed for the monitor. The video driver is supplied by the video
card manufacturer and may be found on the disks that came with your computer. If you
need information on installing a video card or video driver, refer to your computer
documentation for instructions.
Supported Video Display Modes and Refresh Rates
Your video card should support one of the display modes specified in Table 1. If you
select an unsupported video mode, the monitor may stop working or display
unsatisfactory picture quality.
3M Touch Systems Proprietary Information