3Com V7000 - Manual (Page 96)

96 A PPENDIX A: T ELEPHONE I NSTALLATION AND M AINTENANCE
Opening the 3105
Attendant Console
Label Cover For instructions on how to create and print labels, see Printing Labels on
page 24 .
Figure 11 3105 Attendant Console Label Cover Tabs
Moving Your
Telephone Each VCX telephones is uniquely identified by an IP address. You can
move your telephone to another location within your calling domain,
connect it to any Ethernet jack on the LAN, and still maintain all of your
personalized features, speed dials, and extension number.
Swapping
Telephones Your administrator assigns a password for your telephone. This password
associates your telephone extension (and mailbox) with your account.
This may allow you to configure another VCX phone in the system to
duplicate your primary phone. This means if you are away from your
primary phone (for example, in a different office), you can program the
local phone to use your extension. Any calls made to your extension will
ring in both locations and you can access your mailbox from either
phone. See the overview section in the chapter that describes your
telephone for more information.
After you print the
labels and then cut
them out, remove
the plastic cover
from the Attendant
Console by pulling
up on the two tabs
at the top of the
Attendant Console
until the top of the
cover pops off.