3M MicroTouch M150 - Manual (Page 17)

Chapter 2 Setting Up Your M150 FPD Monitor 17
ID Tech MagTek
all MiniMag™ readers all "mini" sized
readers
IDT 3331-02U IDT 3321-33 2180201
IDT 3331-12U IDT 3321-33PP 2180202
IDT 3331-23U IDT 3331-02 2180203
IDT 3331-33U IDT 3331-12 2180204
IDT 3321-02 IDT 3331-23 2180205
IDT 3321-02PP IDT 3331-33 2180206
IDT 3321-12 IDT3301-02 21040103
IDT 3321-12PP IDT3301-12 21040104
IDT 3321-23 IDT3301-23
IDT 3321-23PP IDT3301-33
Figure 6 Card Reader Mounting and Cable Management
65-2305
Connecting the Touch Monitor
CAUTION
You are cautioned that any change or modification to the equipment not expressly approved by
the party responsible for compliance could void your authority to operate such equipment.
To connect the M150 FPD monitor:
1. Turn off your computer. You should always turn off the computer before connecting or
disconnecting any device.
2. Connect one end of the video cable to the video connector on the FPD. Connect the other end
to the video card in your computer.
3. Connect one end of the touch screen cable (either serial or USB) to the FPD. Connect the
other end to an available port on the back of your computer. If you are using a USB
connection, make sure you have installed the TouchWare drivers prior to connecting the
touch screen cable.
3M Touch Systems Proprietary Information