Cable management system – 3M MicroTouch M150 User Manual
Page 19
Chapter 2 Setting Up Your M150 FPD Monitor
19
Route all wiring and cabling away from heat sources and sharp metal edges to avoid
damage. Also, keep the touch screen cable away from sources of electromagnetic and
radio frequency interference.
WARNING
To avoid the risk of electric shock which could result in serious injury or death:
• Do not use a damaged power supply.
• Do not use a power cord that is frayed or otherwise damaged.
Cable Management System
Figure 9 Removing the Cable Management Cover
65-2303
Once you have connected your M150 FPD monitor to your computer, you should take
advantage of the cable management system designed into the base of the M150 FPD
monitor as shown above.
In order to properly route all cables through the cable management system, the cover on
the base unit must be removed. To remove this cover:
1. Push in and lift up on each of the two tabs located on the left and right sides of the cover.
This action will release the cover tabs from the base.
2. Slide the cover back towards you to remove.
3M Touch Systems Proprietary Information