Garmin GNS 530 - Manual (Page 17)

GNS 530(A) Pilot’s Guide and Reference 190-00181-00 Rev. H 1-7
SECTION 1
INTRODUCTION
Figure 1-7 Fuel Flow Selected
The Instrument Panel Self-test Page includes selections
to set fuel on board to full capacity and access the
Checklists Page. This allows the pilot to quickly set fuel
to full limits and display any checklists that have been
entered, such as start up or takeoff checklists.
Setting fuel on board to full (if not
provided by sensor):
1) Turn the large right knob to highlight ‘Set Full
Fuel?’ (Figure 1-8).
Figure 1-8 ‘Set Full Fuel?’ Highlighted
2) Press the ENT Key and verify that fuel on board
now matches the fuel capacity figure. Fuel on
board is reduced, over time, based on the fuel
flow figure.
Viewing the Checklists Page:
1) Turn the large right knob to highlight ‘Go To
Chklist?’ (Figure 1-9) and press the ENT Key.
Figure 1-9 ‘Go To Chklist?’ Highlighted
2) Turn the large right knob to select the desired
checklist, then execute each step (Section
10.3, Utility Page: Checklists) in the selected
checklist.
3) Once the pilot completes the desired checklist(s),
press the small right knob to return to the
Checklists Page. Press the small right knob
again to return to normal operation on the
Satellite Status Page or the Map Page.
4) Once instrument operation has been verified
with the Instrument Panel Self-test Page
displayed, highlight ‘OK?’, and press the ENT
Key.
NOTE: The GNS 530 can hold up to nine checklists
with up to 30 entries in each checklist.