Festool EHL 65 E - Manual (Page 10)

10
rebating depth which has been set can be read
against the notch (1.9).
9.2 Parallel guide
The parallel guide (1.7) is fi tted with a rotary knob
(1.5) in the threaded hole (2.10) on the left side of
the tool.
When planing along an edge a planing width of
between 0 and 65 mm can be set with the stop
after loosening the catch (1.6).
10 Working with the EHL 65 E
- The surface to be planed must be free of metallic
objects.
- First set The desired chip thickness.
- Place The front platen onto The workpiece but do
not allow The planer head to come into contact
with The wood.
- Switch on the planer.
- Guide The planer over The workpiece so that The
platen rests fl at on The workpiece. Press on The
front planer platen when starting to plane and
on The rear planer platen (end of workpiece)
when continuing or fi nishing planing.
10.1 Chamfering
The front planer platen is equipped with a 90° V
groove (2.11) to allow the chamfering of workpiece
edges. This V groove is 2 mm deep, thus produc-
ing a 2 mm edge chamfer with the chip thickness
setting 0.
10.2 Bench-mounted operation
The planer can be operated bench-mounted in
conjunction with the bench-mounting device SE-
EHL (488 524). Detailed instructions are supplied
with the accessories.
11 Accessories, tools
For your own safety, use only original
Festool accessories and spare parts.
The accessory and tool order number can be found
in the Festool catalogue or on the Internet under
“www.festool.com”.
12 Maintenance and care
Always remove the power supply plug
from the socket before carrying out any
work on the machine.
All maintenance and repair work which
requires the motor casing to be opened
may only be carried out by an authorised
service centre.
Customer service and repair. Only
through manufacturer or service work-
shops: Please fi nd the nearest address
at:: www.festool.com/Service
EKAT
1
2 3 5
4
Use only original Festool spare parts!
Order No. at: www.festool.com/Service
The cool air openings in the motor casing must
always be kept clean and unobstructed to ensure
air circulation.
The tool is fi tted with special motor brushes with
an automatic cut-out. When the brushes become
worn the power supply is shut off automatically
and the tool comes to a standstill.
13 Disposal
Do not throw the power tool in your household
waste! Dispose of the machine, accessories and
packaging at an environmentally-responsible recy-
cling centre! Observe the valid national regulations.
EU only: European Directive 2002/96/EC stipulate
that used electric power tools must be collected
separately and disposed of at an environmentally
responsible recycling centre.
Information on REACh: www.festool.com/reach