Festool PLANEX LHS 225 EQ - Manual (Page 22)

22
Problem Possible causes Remedy
Sanding grooves on
the surface Hard sanding pad set down on the
surface at an angle. Use sanding pad IP with interface pad.
Sanding pad is too hard or abrasive
grit too coarse for very soft repair
compound. Use sanding pad IP with interface pad.
Select a fi ner abrasive grit (Brilliant 2 abra-
sive with grit up to P 320).
PLANEX switches
off during work – red
LED on the head of
the machine fl ashes Dust fi lter on PLANEX clogged Clean the dust fi lter on the PLANEX.
Excessive pressure -> machine acti-
vates overheating protection Allow the machine to cool and apply less
pressure; in extreme cases, switch on the
external extraction system and set the extrac-
tion control to setting 6.
PLANEX does not
function Electrical plug is not connected cor-
rectly. Check that the electrical plug is inserted
properly.
If other problems other than those listed occur, please contact your Festool service workshop or your
local specialist dealer.