Festool RO 150 FEQ-FE - Manual (Page 10)

10
Gear-drive eccentric sander
Technical data
RO 150 FEQ/RO 150 FE
Power 720 W
Speed 3300 - 6800 rpm
Sanding stroke 5 mm
Weight (excluding cable) 2.3 kg
Degree of protection /II
The specifi ed illustrations can be found at the
beginning of the operating instructions.
Graphical symbols
Caution. Danger!
Read the operating instructions/notes
Wear ear protection!
Wear protective goggles!
Wear a protective mask!
1 Intended use
As specifi ed, the machines are designed for sand-
ing and polishing wood, plastic, metal, composite
materials, paint/varnish, fi ller and similar mate-
rials.
Materials containing asbestos must not be proc-
essed.
For reasons of electrical safety the machine must
not be damp nor operated in a humid environment.
The machine may only be used for dry sanding.
The user is liable for damage and injury
resulting from incorrect usage!
2 Before starting up, please observe the
following
2.1 Safety instructions
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fi re and/
or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool“ in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
- Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood
and metal). Contact with these dusts, espe-
cially inhaling them, can represent a hazard for
operating personnel or persons in the vicinity.
Comply with the safety regulations that apply in
your country. Connect the electric power tool to
a suitable extraction system.
To protect your health, wear a P2 protec-
tive mask.
Always wear protective goggles because
of possible dangers when sanding.
- The manufacturer’s handling and processing
instructions must be observed without fail if
explosive or self-igniting dusts are likely to oc-
cur during sanding.
- Prevent the penetration of liquid polish into
the tool. The penetration of liquid polish into
the power tool increases the risk of an electric
shock.
2.2 Noise and vibration information
The typical values determined in accordance with
EN 60745 are:
Sound pressure level
82 dB(A)
Sound-power level 93 dB(A)
Measuring uncertainty allowance K = 3 dB
Wear ear protection!
Vibration emission value a
h
(vector sum for three
directions) and uncertainty K measured in accord-
ance with EN 60745:
Fine sanding
a
h
= 4,0 m/s²
Auxiliary handle a
h
= 6,5 m/s²
K = 2,0 m/s²
Coarse sanding a
h
= 3,5 m/s²
Auxiliary handle a
h
= 5,0 m/s²
K = 2,0 m/s²
Polishing a
h
= 5,0 m/s²
Auxiliary handle a
h
= 8,5 m/s²
K = 2,5 m/s²
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with
other insertion tools or if not maintained adequat-
ely. Take note of idling and downtimes of machine!
3 Power supply and start-up
The mains voltage must correspond to
the specifi cation on the rating plate.
The slide switch (1.2) serves as an On/Off switch
(I = ON, 0 = OFF).