Festool DWC 18 - Manual (Page 15)

15
4 Machine features
[1-1] Bit storage
[1-2] Switch
[1-3]
Forward / reverse switch
[1-4] AUTO/MAN switch
[1-5] Depth stopper
[1-6] Bit
[3-1] LED
[3-2] Cable
holder
[3a] Wall mount
The accessories shown or described do not have
to be included with the supplied tool. The speci-
fi ed illustrations appear at the beginning of the
Operating Instructions.
5 Intended use
The drywall screwdriver is designed for the fol-
lowing works:
Main application Screw types Type
D
W
C
18-2500
D
W
C
18-4500
Gypsum plas-
ter boards on
metal profi le rails
(≤ 0.88 mm) Drywall screws
with fi ne thread
×
Gypsum plas-
ter boards on
metal profi le rails
(≤ 2.25 mm) Drywall screws,
self-drilling
×
Gypsum plaster
boards on wooden
constructions Drywall screws
with coarse
thread
×
Gypsum fi bre
boards on metal
and wooden con-
structions Drywall screws
with milling ribs
×
Chip boards/OSB
on wooden con-
structions Wood construc-
tion and chip
board screws up
to 5 mm
×
Charger TCL 3 suitable for
– charging Festool battery packs: BP, BPS and
BPC (NiMH, NiCd, li-ion are recognised auto-
matically.)
– indoor use only.
The user is liable for improper or non-in-
tended use; this also includes continuous
industrial operation.
6 Commissioning
6.1 Charger cable holder [3-2]
Unwind the cable completely from the re-
cess before using the charger.
6.2 Changing the battery pack
Removing the battery pack [2 A]
Inserting the battery pack [2 B]
 Battery pack is ready for use immediately upon
delivery and can be charged at any time.
6.3 Charging the battery pack [3]
The LED [3-1] on the charger indicates the re-
spective operating status of the charger.
LED yellow – lit continuously
Charger is ready to use.
LED green – fl ashing quickly
Battery pack is charged to max-
imum capa city.
LED green – fl ashing slowly
Battery pack is charged with re-
duced current, LiIon is charged
to 80 %.
LED green – lit continuously
Charging is complete or is not
restarted as current charge
status is greater than 80%.
LED red – lit continuously
Battery temperature is outside
the permitted range.
LED red – fl ashing
General fault display, e. g. in-
complete contact, short circuit,
battery pack faulty, etc..
7 Power tool settings
 Setting must be done only when the power tool
is turned off and will be accepted only after
restarting it.
6.1 Changing the direction of rotation [1-3]
Move switch from right to left = clockwise rotation;
Move switch from left to right = anticlockwise ro-
tation.
8 Tool holder, attachments
8.1 Bit holder
The bit holder is used for fast replacement of bits.
CAUTION
Risk of cutting injuries when changing the tool!
 Wear protective gloves!