Edimax Technology EW-7238RPD User Manual
Page 39
39
Defaults
A pop-up window will appear and ask you to confirm,
please click “Ok”. A status bar will indicate the progress
of the reset:
Note:
Restoring settings to the factory default will
restore all settings, configurations and passwords back
to the factory default.
Note:
You can also reset the device to the factory
default by pressing and holding the Reset/WPS button
for at least 10 seconds. See
Upgrade Firmware
Browse
Click “Browse” to open a window and locate the
firmware file.
CANCEL
Click “CANCEL” to cancel and clear the selected file
from the “Browse” box.
APPLY
Click “APPLY” to upgrade to the selected firmware file.
A pop up window will ask you to confirm, and inform
you that the device may not respond for up to a minute
after the upgrade. Please click “OK”. A status bar will
show the progress of the upgrade:
Note:
It is recommended that you use a wired
Ethernet connection to upload the firmware file.
Note:
Do not turn off or disconnect the extender
during a firmware upgrade, as this could damage
the device.