Vitek VT-1688 Capella - Manual (Page 8)

8
4) Steam generator
5) Grill heating element (halogen lamps)
6) Metal lattice. Used only in “Grill” mode.
7) Control panel
8) Tray for water accumulation
9) Tray for oil and grease accumulation.
Control panel (Fig. 2)
1. Display
The display shows current time, time for cooking, power levels and pictograms of working modes.
2. Key «STEAMER»
Press for starting the steamer mode.
ATTENTION: when cooking in steamer mode the microwave radiation is used, therefore use the same precautions
as those that are used when cooking in microwave mode.
3. Key «GRILL/COMBINATION»
Used for entering the grill mode and activation of one of two modes of combined cooking.
4. Key «MICROWAVES»
Used for setting up the power level of microwave radiation. The choice of power level is set in the following order:
HI-(100%), 80%, 60%, 40%, 20%, 0%.
5. Key «DEFROSTING/CLOCK»
Used for entering the defrosting mode, choosing 12 or 24 hours time mode and for setting the time.
6. Key «STOP/RESET»
Press for canceling the preset power level, cooking program or defrosting time.
Note: key «STOP/RESET» does not cancel current time.
7. Handle «TIME/AUTOMENU/WEIGHT»
By turning the handle clockwise the cooking time and the weight of the food to be cooked or defrosted may be set.
By turning the handle counter-clockwise one of the 24 programs of automatic cooking may be set.
Pressing the handle starts the cooking or defrosting process according to the program chosen.
8. Pictograms of 24 modes of automatic food cooking.
Display (Fig. 3)
1. Timer mode pictogram.
2. Blinking dividing points.
3. Chosen weight of food pictogram.
4. Padlocking mode pictogram.
5. Steamer mode pictogram.
6. Grill mode pictogram.
7. Microwave cooking mode pictogram.
8. Defrosting mode pictogram.
9. Pictogram of 3 consequent modes, programmed by user.
10. Current time pictogram.
11. “Display appearance decorative elements” pictogram.
Operation of the oven
Sound signal
Every time you press keys on the control panel you will hear the single sound signal.
Double sound signal means the input error. Carefully check the input parameters and repeat the input.
Current time setting
Example: set current time to 16 hours 30 minutes.
Press and hold the key “DEFROSTING/CLOCK” for about 3 seconds, the sound signal will follow and the display will
show: Hr 24(24 hours time mode).
Note: second pressing the key “DEFROSTING/CLOCK” changes the time mode 12/24 hours.
1. Turn the handle “TIME/AUTOMENU/WEIGHT” and set time “hours” – 16.
2. Press the key “DEFROSTING/CLOCK” for confirming.
3. Turn the handle “TIME/AUTOMENU/WEIGHT” and set time “minutes” – 30, the display will show time 16:30.
4. Press the key “DEFROSTING/CLOCK” for confirming.
The display will show the set time, the pictogram (1) will be on, and the dividing points (2) will be blinking.
Note: if the time setting is not fully completed, in 30 seconds the sound signal will follow and the display data will
be reset back to the initials.
ENGLISH
1688.indd 8 1688.indd 8 27.07.2006 17:11:42 27.07.2006 17:11:42