HONDA 2011 Civic Sedan - Manual (Page 311)

Open the trunk.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Use a flat-tip screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
Remove the bulb from the socket
by pushing the bulb in and turning
it counterclockwise until it unlocks.
Remove the screw from the center
of each fastener on the side of the
trunk lining. Pull the lining back.
Determine which of the four bulbs
is burned out: stop/taillight, back-
up light, turn signal, or side
marker.
Install the new bulb in the socket.
Turn it clockwise to lock it in place.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Test the lights to make sure the
new bulb is working.
Reinstall the inner fender cover.
Then reinstall the holding clips,
and lock them in place by pushing
on their centers.
1.
4.
5.
6.
7.
8.
3.
2.
2.
CONTINUED
Replacing Rear Bulbs
(In Fenders)
Lights
Ma
int
e
na
nce
305
FASTENER
FASTENER
10/06/23 14:40:27 31SNA650_310