HONDA 2011 Civic Sedan - Manual (Page 312)

Open the trunk. Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Reinstall the socket into the light
assembly by turning it clockwise
until it locks. Put the fasteners into the holes on
the side of the trunk lining.
Reinstall the screws.
Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
Test the lights to make sure the
new bulb is working.
Remove the screw from the center
of each fastener on the trunk lid
trim. Pull the trim back.
1.
2.
4.
5.
6.
7.
8.
3.
On all EX-L, Canadian SE, and Si
models
Lights
Replacing Rear Bulbs
(in Trunk Lid)
306
BULBS
SOCKETS
SOCKETS
BULB
FASTENERS BULB
10/06/23 14:40:39 31SNA650_311