HONDA 2010 Accord Crosstour - Manual (Page 355)

To change the bulb, start the
engine, turn the steering wheel all
the way to the right, then turn off
the engine.
Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
Remove the bulb from the fog
light assembly by turning it one-
quarter turn counterclockwise.
Use a flat-tip screwdriver to
remove the holding clip from the
inner fender, and remove the
screw with a Phillips-head
screwdriver.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the fog lights to test the
new bulb.
Put the inner fender cover in place.
Install the holding clip. Lock it in
place by pushing on the center.
Tighten the screw securely.
Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
Reinstall the under cover and
holding clips, and then push in the
head of each clip.
6.
7.
8.
4.
5.
9.
11.
10.
Passenger’s side
Driver’s side
Driver’s side
Driver’s and Passenger’s side
Lights
352
ELECTRICAL CONNECTOR TAB SCREW
BULB
HOLDING CLIP
09/09/29 17:52:39 31TP6600_357
2010 Accord Crosstour