Candy GO W485D-66 - Manual (Page 45)

I
45
H
EN
“AQUAPLUS” BUTTON
By pressing this button you can activate a special new
wash cycle in the Colourfast and Mixed Fabrics programs,
thanks to the new Sensor System. This option treats with
care the fibres of garments and the delicate skin of those
who wear them.
The load is washed in a much larger quantity of water and
this, together with the new combined action of the drum
rotation cycles, where water is filled and emptied, will give
you garments which have been cleaned and rinsed to
perfection. The amount of water in the wash is increased so
that the detergent dissolves perfectly, ensuring an efficient
cleaning action. The amount of water is also increased
during the rinse procedure so as to remove all traces of
detergent from the fibres.
This function has been specifically designed for people with
delicate and sensitive skin, for whom even a very small
amount of detergent can cause irritation or allergy.
You are advised to also use this function for children’s
clothing and for delicate fabrics in general, or when
washing garments made of towelling, where the fibres tend
to absorb a greater quantity of detergent.
To ensure the best performance for your wash, this function
is always activated on the Delicates and
Woollens/Handwash programs.
“DELAY START” BUTTON
This button allows you to pre-programme the wash cycle to
delay the start of the cycle for up to 24 hours.
To delay the start use the following procedure:
Set the required programme.
Press the button once to activate it (h00 appears on the
display) and then press it again to set a 1 hour delay (h01
appears on the display); the pre-set delay increases by 1
hour each time the button is pressed, until h24 appears on
the display, at which point pressing the button again will
reset the delay start to zero.
Confirm by pressing the “START/PAUSE” button (the light on
the display starts to flash). The countdown will begin and
when it has finished the programme will start automatically.
It is possible to cancel the delay start by taking the following
action:
Press and hold the button for 5 seconds until the display will
show the settings for the programme selected.
At this stage it is possible to start the programme previously
selected by pressing the “START/PAUSE” button or to cancel
the process by setting the selector to the OFF position and
then selecting another programme.