Candy GO W485D-66 - Manual (Page 48)

48
EN
“DIGITAL” DISPLAY
The display’s indicator system allows you to be constantly
informed about the status of the machine:
1) WASH TEMPERATURE
When a programme is selected the relevant indicator will
light up to show the recommended wash temperature. The
Temperature button can be used to decrease or increase
the temperature of your chosen wash cycle. Each time the
button is pressed, the new temperature level is shown on the
Wash Temperature Indicator.
2) DOOR LIGHT
Once the START/PAUSE button has been pressed the light first
flashes then stops flashing and remains on until the end of
the wash.
2 minutes after the end of the wash the light goes off to
show that the door can now be opened.
3) SPIN SPEED
Once the programme has been selected, the maximum spin
speed allowed for that programme appears on the display.
Pressing the spin button will reduce the speed by 100 rpm
each time the button is pressed. The minimum speed
allowed is 400 rpm, or it is possible to omit the spin by
pressing the spin button repeatedly.
4) DELAY START LIGHT
This flashes when delay start has been set.
5) CYCLE DURATION
When a programme is selected the display automatically
shows the cycle duration, which can vary, depending on the
options selected.
Once the programme has started you will be kept informed
constantly of the time remaining to the end of the wash.
The appliance calculates the time to the end of the selected
programme based
upon a standard loading, during the cycle, the appliance
corrects the time to that applicable to the
size and composition of the load.
If is selected the automatic washing/drying cycle, at the end
of the wash phase, the drying time remaining to the end will
be shown on the display.
3
{
4
{
1
2
O
7
4
1
2
3
6 5
{
{
{
{
8
{
{
5
h mm