Candy PSA 640__1 FGH - Manual (Page 9)

2 8
INSTALLATION: " G A S C O N N E C T I O N "
The hob can be built-in ; it is type "X" for built-in hob (in compliance with electrical norm
EN 60.335.2.6) ; in class 3 (in compliance with gas norm EN 30.1.1) ; adjoining furniture
should not be higher than the level of the hob.
This appliance is not connected to an evacuation device for the products of combustion. It
must be installed and connected in compliance with the norms in force in the country of
installation. Particular attention should be given to the availability of ventilation. The turno-
ver of air necessary for combustion is a minimum of 2 m
3 /h per kW of power.
Gas connection should be carried out in compliance with the norms in force in the
country of installation. In any case a stop tap, a regulator valve or a release valve for
propane gas, should be fitted to the gas supply pipe. Use only taps, regulator valves,
connectors and flexible hoses with the official mark of approval of the country of installa-
tion.
Built-in appliance
Butane Rigid - Flexible pipe with mechanical connectors (1) -
Propane Rigid - Flexible pipe with mechanical connectors (1) -
Natural Rigid - Flexible pipe with mechanical connectors (1) -
(1) on condition that the hose is accessible along the whole of its length and it should be
located so it cannot be reached by naked flames or deteriorated by combustion gases.
Neither should it be near hot parts of the hob nor anywhere where hot spillages could
affect it.
2 MEANS OF CONNECTION ARE POSSIBLES * :
• CONNECTION BY RIGID PIPE
Connect directly to the threaded end of the inlet pipe.
• CONNECTION BY FLEXIBLE PIPE WITH MECHANICAL CONNECTOR
Screw the nuts of the flexible directly on to the inlet pipe at one end and the gas
supply stop tap at the other.
We recommend this type of connection.
* A tapered connector is supplied in the bag to fit certain models of hobs made for specific
markets. It must be used only in countries where it is compulsory (for example : Great
Britain, Netherlands, Germany). The model PLDA 640 NL only is fitted with the tapered
connector directly on mounting.