Candy PVK 400 X - Manual (Page 18)

18 -
The furniture in which your hob will be installed and all adjacent furniture, should be
made from materials that can withstand high temperatures. In addition, all decorative
laminates should be fixed with heat-resistant glue.
Installation:
• A watertight seal is supplied with the hob.
Before fitting :
. turn the hob upside down, with the glass surface facing downwards.
NB : Make sure the glass is protected.
. fit the seal round the hob.
. make sure that it is correctly fitted to avoid any leakage into the supporting cabinet.
• Leave a gap of at least 5 cm between the appliance and the vertical sides of the
adjacent furniture.
• If, when installing the hob, the lower hob face is adjacent to an area normally acces-
sible when handling or cleaning, fit a partition 1 cm below the base of the hob with a
10x10 cm opening at the rear right-hand corner to avoid any risk of scorching or damage.
Built-in :
Worktop cut-out dimensions :
• Length 560 mm
• Width 490 mm
HOB
Hob with glass surface
facing downwards
Glass surface of hob
Watertight seal
INSTALLATION - BUILT-IN
560 mm
490 mm
595 mm
510 mm
41 mm
10 x 10 cm