Acnodes FES 7510 - Manual (Page 68)

© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
FES7510
Fanless Embedded Controller comes with
Intel Celeron M ULV Processor
VIA ONCHIP IDE DEVICE:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options as shown below:
Descriptions on each item above are as follows:
1. OnChip Primary PCI IDE
The integrated peripheral controller contains an IDE interface with support for two IDE channels. Select
Enabled to activate each channel separately.
2. Primary Master/Slave PIO
The four IDE PIO fields allow you to set a PIO mode (0-4) for each of the four IDE devices that the onboard
IDE interface supports. Modes
0 through 4 provide successively increased performance. In Auto mode, the system automatically deter-
mines the best mode for each device.
3. Primary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the operating environ-
ment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus master driver). If you hard drive
and your system software both support Ultra DMA/33, select Auto to enable BIOS support.
4. On-Chip Serial ATA:
This item controls SATA mode.