Acroprint HandPunch 1000 - Manual (Page 33)

HandPunch 1000 Manual
31
The Set Language command allows the language shown on the HandPunch’s display to
be “localized” for a variety of countries.
- English - German
- Japanese - Russian
- French - Indonesian
- Italian - Portuguese
- Spanish - Polish
The Set Date Format command allows the date format shown on the HandPunch’s
display to be “localized” for a variety of countries.
mm/dd/yy -mm-dd-yy
dd-MMM-yy -MMM dd,yy
dd-mm-yy -ddMMMyyyy
dd/mm/yy
The Set Time and Date command allows the HandPunch’s time and date to be set. This is
normally not necessary as the HandPunch’s time and date are set by the host computer.
The Set Address command allows a unique address to be set for each HandPunch in
a network. For proper operation, each HandPunch in the network must have a unique
address. All units may use any address from 0 to 254. All units are sent with the address
set to 1.
The Set ID Length command allows you to reduce the number of keystrokes required to
enter the ID number by eliminating the use of the ENTER key to complete an ID number
entry. Once the ID Length is set, the HandPunch will automatically accept an ID number
entry once the correct number of characters have been entered.
Set ID Length does not apply when ID entry is made from a card reader. Once the ID
Length is set, the T & A Mode Set command appears, allowing you to configure the
HandPunch to prepare punch data for time and attendance software.
The Set Serial command allows you to set the baud rate communication parameters.
This Upgrade Menu is where the HandPunch code gets input to allow for a Memory
Upgrade
Set Language
Set Date
Format
Set Time and
Date
Set Address
Set ID Length
Set Serial
Upgrade