Operating the phoenix model 1800 – Activeforever Phoenix Model 1850 Knee CPM User Manual
Page 10
OPERATING THE PHOENIX MODEL 1800
Power On and Off
The ON/OFF switch is located at the base of the black control box. When the unit is powered ON it will beep 3 times and the
green power indicator light on the hand-held control pendant will illuminate. This indicates that the unit is ready for use.
Phoenix Model 1800 Knee CPM Control Pendant
The control pendant consists of four (4) control knobs:
1. Flexion: 10 to 110 degrees
2. Extension: -5 to 95 degrees
3. Speed: 1 degree per second at lowest setting, 3 degrees per second at highest setting
4. Pause: 0 to 30 Seconds*
>
To change the flexion and extension settings, simply turn the control knobs to the
desired range of motion.
Note: A 15 degree difference between flexion and extension is required for normal operation. Should the angle settings be
close or overlap, the unit will stop and a continuous beeping alert will sound until the settings are corrected.
>
Set speed and pause by turning the corresponding knob.
>
Press the red button at the top of the pendant to begin cycle or to stop the unit.
>
Close the cover to protect analog dials, and secure with the Velcro strap.
Power indicator light
Patient must have access to hand-held
control pendant at all times.
The Stop/Start button located at the top of
the control pendant allows patient to stop the unit as
needed. As a safety feature, the unit will travel in the
opposite direction when the button is depressed again.
*
Pause option:
Phoenix Models are set to pause at the end of flexion
and extension cycles. This setting can be changed to
pause the CPM device in extension only.