Track seal replacement instructions – Activeforever Phoenix Model 1850 Knee CPM User Manual
Page 16
TRACK SEAL REPLACEMENT INSTRUCTIONS
TOOLS REQUIRED:
Track Seal Kit — Reorder No. Skit 1707A
Adhesive (100% silicon) Reorder Code. ‘Adhesive’
Non-Abrasive Adhesive Remover
INSTRUCTIONS:
Remove the old track seals.
Clean off any adhesive residue from the old track seal. Surfaces must be cleaned thoroughly for the new track seal to adhere
properly. Clean with a quality, non-abrasive adhesive remover such as Goo-Gone.
Attach the track seals to the edge of the track opening by sliding the open side of the new track seal along the edge of the
opening.
Lift the top side of the new track seal and apply a bead of adhesive along the full length of the entire strip.
Ensure the track seals are pressed tightly against the struts after adhesive application.
Run the unit for approximately one (1) hour after application to ensure proper alignment of track seals.
View tight positioning of the track seals against the strut.
Most adhesives require 24 hours for a complete curing process.