Activeforever Spa2Go Portable Spa (Blue) - Manual

BACK WASH INSIDE THE SPA
Lower the temperature to 90 degrees and let
the unit run approximately 10-15 minutes.
This gives the heating element the chance to
cool down. Now unplug the power pack
Using a garden hose, place the hose over the
lower water inlet valve as shown. Turn water
on full blast and hold there for approximately
1-2 minutes. Turn water off and remove
garden hose.
Bleed the air valve that is located on the top of the
filter bucket. Water should spew out within a few
seconds. Close valve snuggly
www.Activeforever.com