Activeforever Spa2Go Portable Spa (Blue) - Manual (Page 3)

Low / No Water Flow
How to check for Pump impeller clogged with debris.
1. Make sure 3 fitting caps have been removed
from inside spa suction & return flow fittings.
These are only used when cleaning filter, to
keep water from overflowing filter tank when
lid is removed. Also check the water level in
the spa. Make sure it is at the required level per
manual instructions.
2. Clean or replace filter cartridge. As the
filter begins to get dirty, the flow of water
slows down as the pump has a difficult time
drawing the water through the dirt
impregnated filter. This is the most common
cause of a spa not heating. The spa
can not heat without good water flow.
Always check to make sure there is power to
the unit. Unit should always be plugged into a
grounded outlet and NEVER use an extension
cord. Check to see if the display is illuminated.
If unsure if there is power to the outlet, plug a
lamp or blow dryer into outlet to ensure it is
working. If you are still unsure, have an
electrician check for you.
www.Activeforever.com